The procedure entry point could not be located

The procedure entry point could not be located

The procedure entry point could not be located

After installing IntraWeb I’m getting the "The procedure entry point @… could not be located…" error when starting the IDE.The message may varies, but it is quite similar to the one below:

If you are seeing the error messages below when you start the IDE, it means the bundled or an old version of IntraWeb is still installed in your HDD, probably an old BPL in the C:WindowsSytem32 folder (or C:WindowsSysWOW64 for Windows 7 64 bits).

Please double check the steps described in Installing or Upgrading IntraWeb to fix this error.